FWC_Installation Instruction Bolt Down

Installation Instructions for a Bolt Down Camper Step

1. Run the power hook up per install instructions. Step

2. Place camper on truck & center camper. Step

3. Under truck locate f our places that you can drill through the bed. Take measurements of the location. Look for obstacles under the truck (fuel lines, frame members, brake lines...etc.). Step

4. Transfer the measurements to the inside of the ca mper. Make sure you can drill and have room to slide the elevator bolt into the hole. Step

5. Drill the holes from inside the camper down through the truck bed. Ideally, you want to drill through the camper floor slats. Step

6 . Inside the campers put the “T” washers on the bolts and slide the bolts into the holes and tap down with a hammer. Step

7 . U nder the truck place the washer and aluminum backing plate on the bolts then use a lock nut to tighten down. Step

8 . Enjoy